Breakout Board for ESP 8266 01.
1. Software to monitor output from the ESP Essentially a debugging tool. For those of you who have the Arduino IDE preinstalled, simply launch Serial Monitor by choosing the port which the CP2102 appears on.. Select the appropriate Baud Rate, and you're good to go.
2. ESP 8266 Type 01 The star of the show.
3. Female Headers We'll be needing these to plug the ESP 01 .
4. Male Header (2 pin) These will be used to connect the power supply and other peripherals to the breakout board(TX,RX).
5. Button This is used to ON/OFF the ESP 01.
6. AMS1117 5V to 3.3V Power Supply.
7. Three 10 k resistance for voltage divider circuit.
8. General PCB,connecting wire,Soldering iron, multimeter etc..
Source: www.bing.com< br/>Images credited to www.bing.com and i.ebayimg.com
